Changed my steering head bearings.... took some pics

ZUKIMON · 08-08-2009, 12:31 AM

Awesome job man. You did everything what I would call the proper way without the proper tools.

What you did is completely fine, and is used by some shops that even have the "proper tools", as it is faster sometimes. I have used this method many times before on cars/trucks and have never had an issue.

One thing I did think of when I saw your adjuster nut and you said you didn't have the socket........Front hub sockets for 4wd trucks have the 4 prongs/pins that you need to turn this nut. The nuts on these trucks are basicaly the same design. You can sometimes get lucky and find one that will fit and they are as cheap as $20 + - from Autozone/Advance. They seem to keep plenty on hand as well. Just a little FYI for anyone out there that may get into this later on. They are usually 1/2" drive though, which means that you need to either have a tourqe wrench that will go down as low as you need, or get a reducer from 1/2" to 3/8" and use the smaller wrench.

I'll shutup now!

Awesome to see the bike is still going strong.

08-08-2009, 12:31 AM	#8
ZUKIMON Is this thing on? Join Date: Feb 2009 Location: Ashe Co, NC (Near Boone) Moto: '01, 929RR Posts: 398	Awesome job man. You did everything what I would call the proper way without the proper tools. What you did is completely fine, and is used by some shops that even have the "proper tools", as it is faster sometimes. I have used this method many times before on cars/trucks and have never had an issue. One thing I did think of when I saw your adjuster nut and you said you didn't have the socket........Front hub sockets for 4wd trucks have the 4 prongs/pins that you need to turn this nut. The nuts on these trucks are basicaly the same design. You can sometimes get lucky and find one that will fit and they are as cheap as $20 + - from Autozone/Advance. They seem to keep plenty on hand as well. Just a little FYI for anyone out there that may get into this later on. They are usually 1/2" drive though, which means that you need to either have a tourqe wrench that will go down as low as you need, or get a reducer from 1/2" to 3/8" and use the smaller wrench. I'll shutup now! Awesome to see the bike is still going strong. __________________ Dirty Harry said there's nothing wrong with a little shooting, as long as the right people get shot.