Handlebars

ZUKIMON · 03-27-2009, 05:49 PM

All good points guys, and I thought of most all of them last night when I was out looking it over. I tried lowering them down past the point that I could move them where I want them and it was such an ackward feeling with them low, that I couldn't get a good feel of where I wanted them. I also tried lowering the tit out and then putting it past the edge of the tripple and then pulled it back up and it was so far forward that it hit the body.

What I did find out is that when I drop it below the clamp and leave the tit out of the pic, it will not budge when I tighten the clamp bolt down tight. I tried and tried and couldn't get it to move any. I think what I will do is to make sure I can get a set from the Bay and cut these. If it doesn't work out for me (and I don't crash) I'll have the others to put back on.

03-27-2009, 05:49 PM	#15
ZUKIMON Is this thing on? Join Date: Feb 2009 Location: Ashe Co, NC (Near Boone) Moto: '01, 929RR Posts: 398	All good points guys, and I thought of most all of them last night when I was out looking it over. I tried lowering them down past the point that I could move them where I want them and it was such an ackward feeling with them low, that I couldn't get a good feel of where I wanted them. I also tried lowering the tit out and then putting it past the edge of the tripple and then pulled it back up and it was so far forward that it hit the body. What I did find out is that when I drop it below the clamp and leave the tit out of the pic, it will not budge when I tighten the clamp bolt down tight. I tried and tried and couldn't get it to move any. I think what I will do is to make sure I can get a set from the Bay and cut these. If it doesn't work out for me (and I don't crash) I'll have the others to put back on. __________________ Dirty Harry said there's nothing wrong with a little shooting, as long as the right people get shot.