DDM HID install GENII Busa

Kerry_129 · 10-05-2009, 01:10 PM

You could make it work, using the timer relay's output to power the other relay's trigger coil - but it would be relatively messy & give you twice the connections/components for potential failure. Also, the timer relay is solid state (transistor doing the switching), so I think its lifespan & reliability is probably much better than a mechanical relay. Since it just uses std. spade terminals, it should be easy to just replace your current one.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-05-2009, 01:10 PM	#14
Kerry_129 Semi-reformed Squid Join Date: Nov 2008 Posts: 531	You could make it work, using the timer relay's output to power the other relay's trigger coil - but it would be relatively messy & give you twice the connections/components for potential failure. Also, the timer relay is solid state (transistor doing the switching), so I think its lifespan & reliability is probably much better than a mechanical relay. Since it just uses std. spade terminals, it should be easy to just replace your current one.